Smoke and carbon monoxide detectors are the simplest life-safety devices in your home — and the most commonly neglected. We install hardwired, interconnected detectors with battery backup, placed where code requires them.
Interconnected means when one sounds, they all sound. In a two-story home or a house with the bedrooms far from the kitchen, that is the difference between a warning and a wake-up call.
Where Detectors Belong
Code requires smoke detection in every bedroom, outside each sleeping area, and on every level of the home — including the basement if you have one. Carbon monoxide detectors belong outside sleeping areas and near fuel-burning appliances.
In older east-side homes, we often find a single aging detector in the hallway covering the whole house — or detectors well past their replacement age. We map the correct coverage and install to it.
Hardwired and Interconnected
Battery-only detectors work, but batteries die and get removed after the third false alarm. Hardwired detectors draw house power with battery backup, so they are always on — and interconnected, so the whole house hears the alarm.
We run the interconnect wiring, mount the units, and test the full chain before we leave. If your home already has hardwired detectors, we can replace aging units and add coverage where it is missing.
Detectors Expire
Smoke detectors have a service life — typically ten years — and the sensors degrade whether the test button works or not. The manufacture date is printed on the back of every unit.
If your detectors are approaching or past ten years, or if you cannot remember when they were installed, it is time. Replacing a full set is a quick job, and it is the cheapest life-safety money you will spend on the house.
CO Detection Matters Here Too
Carbon monoxide is the quiet hazard: attached garages, gas water heaters, and generators running too close to the house. CO detectors belong outside sleeping areas and on every level.
If you have a standby generator, CO detector coverage is part of the conversation — we verify it during the generator install.
Common questions
How many smoke detectors does my home need?
At minimum: one in every bedroom, one outside each sleeping area, and one on every level. We map your home to code during the visit.
How often should detectors be replaced?
Smoke detectors typically expire after ten years — check the manufacture date on the back. CO detectors usually last five to seven years.
What's the difference between hardwired and battery detectors?
Hardwired units draw house power with battery backup and interconnect, so every unit sounds together. Battery-only units work but depend on someone changing the batteries.
My detector keeps chirping. Is it broken?
Chirping usually means a low battery or an expired unit. If fresh batteries do not stop it, the detector itself is likely at end of life and needs replacement.
Related services
Ready when you are.
For fastest service, call now. Prefer to book online? Send a request and we'll call you back to schedule.
(561) 786-1337